How To Build A Mortar Shower Pan

If you are installing tile the mortar bed should be 2-3 inches thick on the outer edge and slightly less at the drain. Wearing waterproof gloves dump the mixed mortar onto the shower floor.

How To Install Mud In A Shower Floor Youtube

Compact the mortar into an even surface and let it dry overnight.

How to build a mortar shower pan. Aim for a height of about 1-12 inches on the border. Use removable 1-inch screed blocks along curbs to establish a 1-inch to 14-inch slope toward the drain. Mix one batch of Thinset and apply with a notched trowel to the subfloor then set the shower base firmly into the mortar.

Remove the top half of the shower drain and plug the drainpipe with a rag to prevent debris from falling into the plumbing. When mixing the mortar use only enough water to obtain a dry pack consistency. If you are using a preformed shower pan the manufacturer of the pan should provide instructions as to how thick the mortar bed needs to be.

Pack the mortar with a wood float then screed the first layer of mortar. Mix a bag of mortar and spread it over the area where the shower base will sit. This type of mortar creates a great water-resistant barrier that can support the weight of the shower unit.

Frame out the shower pan using 2 by 6 inches 51 cm 152 cm boards. First by hand then with the trowel spread the mortar around the base mounding it higher around the edges. Build first layer of shower pan and install liner.

The mortar should be about 1 inch thick. Check the manufacturers installation instructions and see what they recommend in case the use of mortar is discouraged. To fit the opening.

There are a few types of mortar to consider when building a shower pan. Mix the mortar in a wheelbarrow not a bucket. Spread the Mortar to the Borders.

Measure the distances between the studs on your walls where you plan on building your shower pan and write. Dump the mortar onto the floor spreading it with a wood float and sloping it from the top of the guides or the bottom wall plate on larger stalls to the top of the drain flange. And unsurprisingly this is where most DIYers make a mistake try to take a shortcut or just get it wrong.

The ideal mortar for a shower pan is a mix of standard cement mix with sand and Portland cement. Ensure to cover the studs with stucco wire smoothen the surface. How to properly build a tiled shower tray.

The most important part of the entire shower project to get it right is absolutely the floor pan. Let this dry overnight. Most installers recommend putting a bed of mortar down for the shower base to sit on.

Using the mud mixture build the first layer with a slope towards the shower drain from the wall with ¼ to 38 inch per foot.

Diy Shower Pan Final Steps The Space Between