How To Install A Tension Shower Curtain Rod On Tile

The weight of the curtain. The state of the wall.

Never Fall Shower Curtain Rod Instructions Youtube

With your partner holding the free end of the curtain rod match up the holes in the side youre installing to the wall anchor holes.

How to install a tension shower curtain rod on tile. Install the anchors that came with the curtain rod kit into the holes. Twist the right side of the rod towards you until it is an inch or two longer than the distance between the walls. Installing shower curtain over ceramic tile.

You should also use a bit smaller than the diameter of the tile to ensure that you do not damage the tile while drilling the hole. According to do it yourself there is no standard height for hanging a shower curtain rod. Use a tile bit.

Poorly installed tension rods. Clean the tile thoroughly then discreetly mark where you wish to install the bar. They manage their need by putting a temporary rod or tension rod between walls.

They do it to avoid risking tile layout. First adjust your shower curtain to be a few inches longer than the shower. You can put a piece of blue painters tape and mark where you want to drill.

Clean the tile thoroughly then discreetly mark where you wish to install the bar. Use adhesive shower curtain rod holder or rod retainer. Place a piece of duct tape on the tile where the shower rod will be installed and mark the spot where you will drill with a pen.

Installing a spring curtain tension rod is simple and easy to do. Reposition your shower rod between the shower walls. If you intend to install curtains on your own it is not a difficult process at all.

Once you have the hole drilled it will be necessary to use a small hammer to tap it into place. Many people hire professional people to perform the task. Screw the mounting brackets into place.

Hang curtain over the rod with easy. Then push the end in some and slowly release once you position the rod. Twist the adjustable end of the new tension mount flanges to increase the tension on the shower rod.

Aside from the ease of installation this rod is also easy to remove. Repeat steps 2-6 on the other side of the rod. Use non-slip rubber pads or felt pads.

Hold the drill firmly and start drilling at a slow speed. Measure from the floor on both sides of the shower enclosure to ensure that the rod will be level and then measure inward from the outer wall of the enclosure. The additional tension and the rubber.

Drill the holes for the mounting brackets. Place the shower rod at least 74 inches 188 cm above the shower floor. Hang the shower curtain rod at an angle with one end several inches higher than you want it.

It will depend on how high off the floor you want the shower curtain to hang. Place tape on the walls according to your measurements for shower curtain tension rod. The tape helps prevent the drill from slipping against the tile when drilling begins.

Mark the spots where the mounting bracket for the shower curtain rod will be affixed to the shower wall. With this type of curtain rod there is no drilling no tools and no screws required. Then slide the cover in place to cover up the screw brackets.

How to keep tension rods from falling down or slipping. Firmly hold the rod in place and drill in all three screws. The rubber feet will secure the shower curtain rod to the wall.

Then put on eye protection. Remove the duct tape. Drill the hole through the center of the tile.

Mark the locations of the holes with a pencil. Glue rubber shelf lining on the wall. Dont push too hard once you get it started dont let the drill slip and then hold steady and allow the drill to do the work.

Drill into the tile at the spot that you have marked on the duct tape. The final step in our process is to hang the shower curtain.

How To Install A Shower Curtain Rod Ylighting Ideas